software for picture engraving opt laser

In this case, the focusing procedure will fail. This is because the Laser Module did not reach the optimal height during the focusing procedure. For example, Line B is the thinnest line in the following picture, but it is not the best engraved line. However, sometimes the engraving result does not contain the best engraved line. Lines engraved before or after it are thicker.) The lines engraved before or after the best engraved line should be thicker than it, as illustrated by the following figure. Then, the machine adjusts the height of the Laser Module based on the reference point to engrave a series of lines on the material.Īt the optimal height, the laser is best focused and can engrave the thinnest line on the material surface, which is called the best engraved line. Instead, you can manually set a reference point. The manual focusing procedure does not necessarily use the default value for focal length. During auto focusing, the machine adjusts the height of the Laser Module based on the default focal length to engrave a series of lines on the material. (1) Engrave a few lines at different heights.Įach laser engraving and cutting machine comes with a default focal length value, which is not always accurate.

The measurement of focal length mainly involves the following procedures. Snapmaker designs both the Auto Focus and Manual Focus modes to help you measure the focal length.

Set Work Origin to Start Laser Engraving and Cutting in LubanĤ.2 Measure the Focal Length 4.2.1 How It Works: Measure the Focal Lengthįocal length is the distance from the center of the lens to the focal point of the lens. By setting an accurate focal length value, you will be able to position the focal point right on the surface of the material, which ensures the best focusing result. Set Work Origin to Start Laser Engraving and Cutting on the Touchscreen Prepare the G-Code File for Engraving and Cutting

Use Camera Capture to Start Laser Engraving and Cutting in Luban The engraving and cutting effects depend on the material you choose and the parameters you configure, regardless of which workflow you opt for. This section provides the three workflows you can follow to start laser engraving and cutting. Depending on the positioning methods and operating consoles you choose, the workflows can be different. If you set the work origin, you can start laser engraving and cutting by using Luban or the Touchscreen. If you use the method of camera capture, you must connect your machine to Luban, and use Luban for the subsequent operations. Snapmaker provides you with the following two methods to help you position the laser working area: 4.1 Laser Engraving and Cutting Workflows

Software for picture engraving opt laser